Vertiv Liebert AC8 - Page 171

Initialization String (InitString)
ATS0=1
Any string (up to 40 characters); for international
dialing, add +GCI=xx, where xx is the country code
(except B5 countries—see Table 7.9 on page75)
Enable Modem Diagnostic Messages N (disable) Y (enable)
Modem Dial Prefix
ATE0X4DT
Any string
Modem Hang Up Delay After a Call 10 seconds Any number (up to 99 seconds)
DIP SWITCH SETTINGS
Feature Default Other Options
8-position DIP switch All are OFF (down)
May be used to reset password to factory default (see
9.9.1- Change Password)
OTHER SETTINGS
Feature Default Other Options
Change state of outputs - automatic
or manual control
AUTO (automatic control)
Force an output ON / OFF via Manual Output Ctrl menu
Force all outputs ON via hardware switch
Password AAAA Any 4 characters (see Table 7.1 on page53 for valid characters)
Reset common alarm with silence N (not reset) Y (reset with silence)
Battery connected Y (connected) N (not connected)
Table B.2 Liebert AC8 - other default settings (continued)
NOTES
Vertiv | Liebert® AC8 User Manual | 165