Enable Modem Diagnostic Messages
Enabling modem diagnostics will provide the following additional information about the modem to the
computer using the Service Terminal Interface:
Hang-up modem
Modem model number
No dial tone
No carrier
Busy
No answer
Pager checksum error
Pager pin number error
Error (indicates incorrect phone number, dial prefix or modem initialization string)
For alphanumeric pager failures:
Paging company non answer on 1st
Paging company non answer on 2nd
Paging company non answer on Last
Paging company non answer on Handshake
• At the Enable Modem Diagnostic Messages prompt, enter Y (Yes - enable) or N (No - disable).
The current setting appears in brackets—[N] in the following example.
>ENABLE MODEM DIAGNOSTIC MESSAGES-YES(Y) OR NO(N)?
>[N]
>[
>COMMAND SUCCESSFUL
• Press Enter to proceed, or Escape to cancel the entry. If you make a change, a confirmation
message appears: “Command Successful.”
Change Modem Dial Prefix
• At the Change Modem Dial Prefix prompt, enter the prefix to be dialed. The current setting
appears in brackets—[ATE0X4DT] in the following example.
>CHANGE MODEM DIAL PREFIX.
>[ATE0X4DT]
>[
>COMMAND SUCCESSFUL
• For international dialing involving countries that do not support B5 (see Table 7.9 on page75),
add country codes to the initialization string using the format +GCI=xx, where xx is the
country code.
(Note: Also requires MT5600SMI modem; model number is on modem label.)
See Modem Setup - Initialization String on page73 for more information.
Vertiv | Liebert® AC8 User Manual | 77
To Next Page
Loading...
