WAGO 750 Series User Manual

Step-by-Step Guide to your own Linux Application • 97
Unpack the Source Code
WAGO-I/O-SYSTEM 750
Linux Fieldbus Coupler
5.2 Unpack the Source Code
The Linux kernel source codes and the source code of the example programs
described in the documentation are on the CD in the following file:
CD:/linux/sources/. The installation should by all means be done in the user
mode, not in the super user mode:
> cd /media/cd-rom/linux/sources
(in S.U.S.E, a CD drive is mounted in /media/cd-rom if it was linked via
Konqueror, for example)
> sh install.sh
Call installation script
The installation is done automatically. During the installation a
/uclinux-dist
directory is created in the home directory of the user in which are stored the
files required for the compilation of the Linux kernel, for the creation of the
file system and for the compilation of the application programs.

WAGO 750 Series Specifications

General

Protection Class	IP20
Bus Couplers	PROFIBUS, CANopen, Ethernet
Modules	Digital Input, Digital Output, Analog Input, Analog Output
Mounting	DIN rail mounting
Voltage Supply	24 V DC (typical)
Communication Protocol	Depends on the bus coupler (e.g., PROFIBUS, CANopen, DeviceNet, Ethernet)
Digital Input Channels	Varies by module (e.g., 8, 16 channels)
Digital Output Channels	Varies by module (e.g., 8, 16 channels)
Analog Input Channels	Varies by module (e.g., 2, 4, 8 channels)
Analog Output Channels	1, 2, 4 channels (depending on module)
Width	12 mm, 24 mm (typical module widths)
Number of Channels	Varies by module type
Current Consumption per Channel	Varies by module type