WAGO 750 Series User Manual

118 • Step-by-Step Guide to your own Linux Application
Debugging of User Space Programs
WAGO-I/O-SYSTEM 750
Linux Fieldbus Coupler
5.12.2 Preparation for Using the Debugger
GDB has automatically been installed on your PC when installing the
toolchain.
When delivered, the GDB server is already on the Linux fieldbus controller
and can be called directly.
In order to use the graphical front end DDD on the PC, it must be installed
over the distribution that is used. With the S.U.S.E Linux distribution, this is
completed as follows:
1. Click on the program “Control center” and select
“Yast2 Module” " Software " Software installation.
2. A search window opens. Enter DDD and press the Enter key.
3. If the search result shows the DDD application, install it. If the DDD is
not in the distribution, it can be downloaded at:
www.gnu.org/software/ddd/.

WAGO 750 Series Specifications

General

Protection Class	IP20
Bus Couplers	PROFIBUS, CANopen, Ethernet
Modules	Digital Input, Digital Output, Analog Input, Analog Output
Mounting	DIN rail mounting
Voltage Supply	24 V DC (typical)
Communication Protocol	Depends on the bus coupler (e.g., PROFIBUS, CANopen, DeviceNet, Ethernet)
Digital Input Channels	Varies by module (e.g., 8, 16 channels)
Digital Output Channels	Varies by module (e.g., 8, 16 channels)
Analog Input Channels	Varies by module (e.g., 2, 4, 8 channels)
Analog Output Channels	1, 2, 4 channels (depending on module)
Width	12 mm, 24 mm (typical module widths)
Number of Channels	Varies by module type
Current Consumption per Channel	Varies by module type