WAGO 750 Series User Manual

102 • Step-by-Step Guide to your own Linux Application
Setup of the Development Environment
WAGO-I/O-SYSTEM 750
Linux Fieldbus Coupler
Press the <Strg> + <a><x> kex combination to terminate minicom.
In order that the backspace key functions properly, the option "Backspace
sends Del(ete)“ needs to be set. In minicom, this is done via the <Strg> +
<a><t><b> key combination.
In the Windows operating systems Hyperterminal is the recommended
program for the serial terminal communication. The following figure shows
the required settings.
Fig. 5-2: Configuration of the serial interface in Hyperterminal p0860010d

WAGO 750 Series Specifications

General

Protection Class	IP20
Bus Couplers	PROFIBUS, CANopen, Ethernet
Modules	Digital Input, Digital Output, Analog Input, Analog Output
Mounting	DIN rail mounting
Voltage Supply	24 V DC (typical)
Communication Protocol	Depends on the bus coupler (e.g., PROFIBUS, CANopen, DeviceNet, Ethernet)
Digital Input Channels	Varies by module (e.g., 8, 16 channels)
Digital Output Channels	Varies by module (e.g., 8, 16 channels)
Analog Input Channels	Varies by module (e.g., 2, 4, 8 channels)
Analog Output Channels	1, 2, 4 channels (depending on module)
Width	12 mm, 24 mm (typical module widths)
Number of Channels	Varies by module type
Current Consumption per Channel	Varies by module type