EasyManua.ls Logo

WAHLAP TECH PUSHING POINTS - Page 28

WAHLAP TECH PUSHING POINTS
121 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
For set item, refer to P3
(i)
(j)
(k)
(l)
For set item, refer to P2
(e)
(f)
(h)
6.
Select the item to be set by pressing [↑] and [↓].
7.
Change the setting-value of the selected item by pressing [←] or [→].
TILT
OFF:Ignore (no error)
AUTO:After the tilting-error
occurs (E02), the game will be
restored after 20 seconds.
MANUAL:After the tilting-error
(E02) occurs, the error must be
manually removed.
MANUAL
f
Tilt has been detected
(For TILT location, refer to the
section on P33)
MOVE SPEED
i
Speed setting of jacking-rod moving
FAST
MIDDLE
SLOW
FAST
SHUTTER TIME
k
It is the time to close the sealing-plate
after the game is over (unit: second)
30
OPEN:Sealing-plate normally-opening
CLOSE:Sealing-plate normally-closing
10~990:It is the time to close the
sealing-plate (in unit of 10 seconds)
PUSHER MODE
j
Setting of jacking-up
ONCE: There is only one jacking-up
chance in the limited time.
RETRY: There are many jacking-up
chances within the limited time.
ONCE
PRIZE ERROR
l
Should the error be reported after the
sealing-plate is closed?(E51)
OFF:The error shall not be
reported
ON:The error shall be reported
OFF
OFF:No time-limit
10~
990:Time-limit(unit:10
seconds)
TIME LIMIT
e
30
20
AUTO
180
ON
FAST
RETRY
10
ON
Time limit for game (unit: second)
※If the jacking-up is not completed, the
jacking-rod will start the jacking-up in the
existing position.
DEMO SOUND
ON
h
OFF:There is no sound when DEMO is
performed.
ON :There is the sound when DEMO is
performed.
BGM1:DEMO BGM1(Christmas style)
BGM2:DEMO BGM2(Samba style)
There is no sound when DEMO is
performed.
※DEMO cannot be set when DEMO
ACTION is OFF.
DEMO ACTION
OFF:No DEMO occurs.
030~
600:DEMO period (unit:
30 seconds)
180g
Set DEMO period in the standby
(unit: second)
SN Item Name Contents Set Range
Initial
value
SEGA
Recomended
Setting

Table of Contents