Wallace Perimeter Security ALPHA - Page 132

132
wallaceperimetersecurity.comPhone: 866.300.1110
USER RELAYS - PROGRAMMING PROCEDURE
Table 9. User-Programmable User Relays - Funcon Opons
No� Name Descripon
25 DC Power Alert Acve when on AC power or the baery voltage is above 21V.
When used with User Relay 2, this opon can shed electrical loads
to conserve baery energy.
26 Free Exit Loop Detector
pulse
Outputs a 250ms pulse when the free exit vehicle detector is
tripped.
27 Not Open (w/AC power) Acvated when gate is not on open limit and AC power is present.
Deacvated when AC power fails or the gate is on open limit.
28 Flasher (w/AC power) Output idencal to relay #19 and pulses relay 500 ms/sec when
the gate is not on open limit and AC power is present. Deacvated
when AC power fails or the gate is on open limit.
29 Arm Entry Ticket
Dispenser
Not funconal in the Kinec operator.
30 Arm Exit Ticket Dispenser Not funconal in the Kinec operator.
31 Reset Ticket Dispenser
Pulse
Not funconal in the Kinec operator.
32 Backo Pulse Not funconal in the Kinec operator.
33 Transient In Pulse Not funconal in the Kinec operator.
34 Transient Out Pulse Not funconal in the Kinec operator.
35 Tenant In Pulse Not funconal in the Kinec operator.
36 Tenant Out Pulse Not funconal in the Kinec operator.
37 Special In Pulse Not funconal in the Kinec operator.
38 Special Out Pulse Not funconal in the Kinec operator.
39 Unknown In Pulse Not funconal in the Kinec operator.
40 Unknown Out Pulse Not funconal in the Kinec operator.