98
wallaceperimetersecurity.comPhone: 866.300.1110
INSTALLER MENU
Installer Menu
The Installer Menu consists of several funcons which can be modied using the SmartDC Controller
buons or congured through the use of a laptop computer and the S.T.A.R.T. soware available from the
Nice | HySecurity website.
The Installer Menu opons provide more advanced conguraons for the Kinec operator. Access to the
Installer Menu is through the User Menu. The navigaonal buons are the same in both menu modes.
To review how to use the navigaonal buons on the SmartDC Controller, refer to “Using the SmartDC
Controller Buons in Menu Mode” on page 85.
To access the User or Installer menus,
the operator must be in Run Mode
with a gate status showing on the
display. The motor cannot be engaged
and the gate cannot be moving.
The menu items Usage Class, Gate
Handing, Gate Weight, and Gate
Length must be congured before
the operator will funcon. Refer
to “Programming the Inial Setup
Menu” on page 61.
In the pages that follow, a detailed view of the
more commonly used menus is provided.
To access the Installer Menu, take the following steps:
• Reseng the OPEN & CLOSE Limits
• Adjusng the Gate Speed
• Adjusng the IES Sensivity
• Reinstang the Factory Defaults
• Enabling the Fire Department Override
“Table 6. SmartDC Controller - Installer Menu Funcons” on page 106 describes the Installer Menus,
supplies the factory defaults, and references the hard-wire connecons.
For informaon on how the menu buons funcon, review “Using the SmartDC Controller Buons in
Menu Mode” on page 85.
The CLOSE TIMER display
appears indicang you have
accessed the User Menu.
2. To access the Installer
Menu, simultaneously press
OPEN and RESET.
Release the buons and
the LEARN LIMITS display
appears indicang
entrance to the Installer
Menu. The LEARN LIMITS
display is the rst item in
the Installer Menu.
1. Start at a gate status
display. To bypass the
Operator Status Displays,
press the MENU buon
twice.
To Next Page
Loading...