Wallace Perimeter Security ALPHA - Page 162

162
wallaceperimetersecurity.comPhone: 866.300.1110
TROUBLESHOOTING
Table 12. SmartDC Controller - Troubleshoong
Ref.
No�
Display Descripon
Possible Causes Soluons
Condion Alert, Error or Fault
46 ERROR 8
RPM SENSOR
RPM sensor
disconnected.
Motor Encoder or wires are
damaged or unplugged.
Check wiring from the motor
to the SmartDC Controller
board.
47 ERROR 9
BATTERY
DISCONNECT
The SmartDC Controller
detected there is no
baery connected.
The baeries are
disconnected, or a wiring
fault exists. Kinec
operators ship with a wire
disconnected to prevent
baery drain.
Replaced by Alert 28 in
h5.57 soware version for
AC powered operators.
1. Ensure the red wire in the
upper le corner of the
control box is connected to
the switch.
2. Correct any losses with
baery wiring.
3. Check the 35-amp fuse on
the circuit board.
48 ERROR 10
SLOWDOWN
SWITCH
Not used in Kinec
operators.
N/A N/A