WinGD X72 - Engine Control System − Functions

Operation4002−1/A1
Winterthur Gas & Diesel Ltd.
8/ 22
3. Engine Control System − Functions
The functions of the engine control system (ECS) are as follows:
D Starting valve control (see paragraph 3.1)
D Servo oil pressure control (see paragraph 3.2)
D Exhaust valve control (see paragraph 3.3)
D Cylinder lubricating control (see paragraph 3.4)
D Engine speed and crank angle sensor (see paragraph 3.5)
D Diesel fuel pressure control (see paragraph 3.6)
D Diesel fuel injection control (see paragraph 3.7)
3.1 Starting Valve Control
The CCM-20 of each cylinder opens and closes the starting valve CV7241−48C
during the engine starting sequence at a specified crank angle until the conditions for
engine operation on fuel oil are established. For more data, see 2728−1 Starting
Valve.
The MCM-11 controls the common start valve CV7013C. The IOM-10 controls the
common start valve CV7014C. This makes sure of redundancy.
2015-12
Engine Control System