WinGD X72 - Radial Oil Supply; Vertical Oil Supply

Operation
7218−1/A1
Winterthur Gas & Diesel Ltd.
11/ 12
8.2 Radial Oil Supply
The nozzle tip in the lubricating quill has holes in specified positions. The lubricating
oil flows out of these holes at high pressure. This gives equal lubrication on to the
cylinder liner wall (see Fig. 6).
Fig. 7: Radial Oil Supply
8.3 Vertical Oil Supply
The ECS parameters adjust the timing, which gives the position and percentage of
cylinder lubrication oil on the cylinder liner wall and between the piston rings
(see Fig. 7).
The ECS parameters also adjust the timing (with its percentage supply of the feed
rate) during the first commissioning.
ABOVE − 70%
INTO − 25%
BELOW − 5%
WCH02286
Fig. 8: Vertical Oil Supply
2015-03
Cylinder Lubrication