Maintenance3303−5/A1
Winterthur Gas & Diesel Ltd.
4/ 4
6) Attach the round nuts (2, Fig. 6) to the
elastic bolts (3).
7) Use the pre-tensioning jack 94315 to
tighten the four round nuts (2) refer to
9403−4.
4. Completion
1) Attach the piston to the crosshead, refer to 3303−3, paragraph 6.
2) Remove all tools and equipment from the area.
2015
Top End Bearing Cover − Removal, Inspection and Installation
WCH02662
3
1
2
Fig. 6
To Next Page
Loading...
