WinGD X92 - Page 298

Maintenance3326−1/A1
Winterthur Gas & Diesel Ltd.
4/ 13
WARNING
Injury Hazard: The weight
of the crosshead pin is
4830 kg. Use only
approved equipment and
sufficient personnel to lift
and move the crosshead
pin.
31) Attach the two lifting eye bolts
(94045-M56, Fig. 6) to the guide shoe
(1).
32) Attach the shackle (94019L, Fig. 7) to
the column on the other side.
33) Attach the second manual ratchet
(94016-015) to the shackle (94019L) on
the column.
34) Attach the lower hooks (1) of the two
manual ratchets (940016-015) to the
two upper shackles (2) of the lifting tool
(94337) on connecting rod.
35) Attach the lower hook of the spur
-geared chain block (94017-051) to the
shackle of the lifting tool (94324).
36) Apply light tension to the chains of the
two manual ratchet (94016-015). Make
sure that the primary load stays on the
chain of the spur-geared chain block
(94017-051).
37) Use the spur-geared chain block
(94017-051, Fig. 8) to carefully lift the
crosshead about x= 300 mm above the
pin hole center (1).
38) Attach the chains of the two
spur-geared chain block (94017-040) to
the two lifting eye bolts (94045-M56)
Note: If necessary, install the supports
(94332A / 94322) for one
crosshead; i.e, do the steps 39) to
44).
WARNING
Injury Hazard: The weight
of the support (94322A) is
53.4 kg and the weight of
the support (94322) is 56.3
kg. Use approved
equipment or sufficient
personnel to lift and move
the supports.
2015
Crosshead Pin − Removal / Installation / Clearance Checks
Fig. 6
94045-M56
94019L
94016-015
Fig. 7
94337
1
2
94324
94017-051
94017-051
94017-040
94322A
94016-005
94045-M56
Fi
g
. 8
1
94019P
94017-040
94019L
94016-015
1
WCH03035
WCH03035