WinGD X92 - Page 449

Maintenance
6606−1/A1
Winterthur Gas & Diesel Ltd.
3/ 8
11) Attach the three lugs (94048−M42,
Fig. 3) the front of the SAC (1).
12) Attach the left and right supports
(94663A, 94663B) to the receiver with
the screws (2).
13) Torque the screws (2) to 136 Nm.
14) Attach the chain 94020A to the outer
lugs 94048−M42.
15) Remove the safety lugs (94663C) from
their stowage positions the left and
right supports.
16) Attach the safety lugs 94663C to the
SAC (1, Fig. 4).
17) Attach the safety chains 94663D to the
safety lugs and the left and right
supports.
18) Put the two trolleys 94015F in position
on the beam (2).
19) Attach the manual ratchet 94016-003 to
the chain 94020A and an applicable
strong-point on the engine room wall.
20) Operate the the manual ratchet
94016−003 to pull the SAC a small
distance from the receiver.
21) Attach the chain block 94017-028 with
shackle 94019L to the trolley 94015F
and the hook to the center lug of the
SAC.
22) Operate the chain block 94017-028 to
get sufficient tension to hold the mass
of the SAC.
2015
Scavenge Air Cooler: Removal and Installation
Fig. 3
Fig. 4
I
94663C
94663D
1
9408−M42
94020A
WCH02970
94663B
2
94663A
FRONT OF SAC
94015F
94017−028
94016−003
94663D
94663D
WCH02970
I
2
1
WCH02970