1126700 SmartPAC 2 User Manual
2-2 Installation
Before You Start
This chapter describes how to install SmartPAC 2 and some of its options. It is organized in
the following sections:
• Installation Guidelines, page 2-3
• Connecting Wires to Terminal Block Connectors, page 2-5
• Terminating Cable Shields, page 2-5
• Checking the Press, page 2-6
• Mounting the SmartPAC 2 Control Enclosure, page 2-7
• Installing SmartPAC 2 as a Panel Mount, page 2-8
• Installing the Resolver, page 2-10
• Connecting AC Wiring, page 2-14
• Connecting Stop Circuits and Input Check Circuit, page 2-15
• Connecting to Network, page 2-17
• Adding or Upgrading DiProPAC or ProCamPAC, page 2-18
• Connecting DiPro Sensor Interface to SmartPAC 2, page 2-22
• Connecting Programmable Cam Channels, page 2-25
• Turning on Power to SmartPAC 2, page 2-33
• Verifying Installation of DiProPAC and ProCamPAC, page 2-34
• Zeroing the Resolver, page 2-35
• Installing the Position Sensor (Optional), page 2-37
• Setting Up High Speed Version of SmartPAC 2 (Optional), page 2-41
• Final Checkout, page 2-41
• Wiring Setup Mode Circuit, page 2-31
• Wiring a Remote Reset Switch (Optional), page 2-31
• Wiring a Sensor-Disabled Output (Optional), page 2-31
• Wiring the ProCamPAC Output with Your Mechanical Top Stop Cam Switch (Optional),
page 2-32
• Wiring Tables for SmartPAC 2 Options, page 2-43
READ INSTALLATION INSTRUCTIONS BEFORE STARTING INSTALLATION
If you install SmartPAC 2 yourself, read this installation chapter carefully, plan your installation, and
figure out what steps you will follow before you start drilling holes, running conduit, or cutting wires.
LEARN TO USE SMARTPAC 2 BEFORE INSTALLING ON A PRESS
If you have not used SmartPAC 2 before, learn how to initialize and program it before installing it
on a press. On the bench, connect your unit to a resolver (see page 2-10) and to AC power (see
page 2-14) so that you can access all the menus and make settings. See Chapter 3 for
instructions on using the keyboard and displays, Chapter 4 for using Initialization mode, Chapter 5
for using Program mode, and Chapter 6 for using Run mode.
To Next Page
Loading...
Need help?
General
