SmartPAC 2 User Manual 1126700
Program Mode 5-45
3. Set the Off angle on the crank angle clock, using the Up () and Down () cursor keys.
As you press the Up () cursor key, the Off cursor moves clockwise around the display,
and the Off angle value increases. As you press the Down () cursor key, the Off cursor
moves counterclockwise around the display, and the Off angle value decreases.
The precise Off angle value is displayed in the window inside the clock display. In
Figure 5-51, the Off angle is set to 311°.
4. Press RESET when you are finished to return to the Cam Channel Program Type Menu.
Setting DSV ON Channel Timing
The PROGRAM DSV ON item on the Cam Channel Program Type Menu enables you to set
the amount of time (in seconds) after the press stops that a DSV On cam channel remains on.
A DSV On cam channel turns on when the Dual Safety Valve is energized and the press starts
and turns off when the DSV is de-energized and the press stops. You set the DSV delay time
on the Cam Channel DSV On Program Screen, which is shown in Figure 5-52.
DSV On cam channel programming is useful for controlling conveyors and other accessories
that must operate for a short time after the press stops. In addition to setting a specific time for
the Off delay, you can also select the OUTPUT FOLLOWS RESOLVER MOTION setting,
which keeps the cam channel on until resolver rotation falls to 6 SPM.
To set the DSV delay time, do the following:
1. Select PROGRAM DSV ON on the Cam Channel Program Type Menu. The Cam
Channel DSV On Program screen displays.
Figure 5-52. Cam Channel DSV On Program Screen
To Next Page
Loading...
Need help?
General
