SmartPAC 2 User Manual 1126700
Reporting Downtime and Scrap to LETS G-15
To respond to this prompt, perform the following steps:
1. Press RESET to clear the message. The Dialog Menu (see Figure G-9) displays.
2. Highlight the downtime reason you want (in Figure G-9, MECH PROBLEM is selected as
an example), using the Up () or Down () cursor key, and press ENTER.
3. If Auto Backfill has been enabled on the Set Communications Menu (see Table G-1,
page G-9), the downtime reason you selected is automatically “backfilled” (i.e., assigned
to the period from the time that the press was stopped up to entry of the next downtime
reason or the BACK ON LINE selection). If a SmartPAC 2 fault has already been
assigned to this period of press inactivity, that fault will be documented as having
consumed 1 second and the remainder of the period filled with the downtime reason you
selected. If the period has been documented as Idle Time, your downtime reason will
Figure G-8. SmartPAC 2 Run Mode Main Menu with Forced Dialog Message Displayed
Figure G-9. Dialog Menu
To Next Page
Loading...
Need help?
General
