1126700 SmartPAC 2 User Manual
4-42 Initialization Mode
SAVE TO USB DISK
(INITIALIZATION – DIAGNOSTICS – SAVE TO USB DISK)
This item enables you to save the error/event log (see page 6-30), screen captures (see
page 3-22), and other data maintained in a special SmartPAC 2 buffer to a USB disk. Once
the data has been saved, you can remove the USB disk, transfer the information to a computer,
and e-mail it to Wintriss Tech. Support or to another recipient (see MESSAGING, page 6-32).
This function is useful if your SmartPAC 2 is not networked. To save information to a USB
disk, do the following:
1. Make sure a USB disk is installed in the USB connector on the SmartPAC 2 board (see
steps 1 through 4 of the Saving a Screen Capture to a USB Disk, page 3-23).
2. Access the Main Initialization Menu, select DIAGNOSTICS, and when the Diagnostics
Menu (see Figure 4-29) displays, select SAVE TO USB DISK. The following messages
appear in succession:
PLEASE WAIT WHILE THE DATA IS BEING TRANSFERRED TO THE USB DISK.
THIS MAY TAKE UP TO ONE MINUTE TO COMPLETE . . .
THE USB DISK TRANSFER HAS FINISHED AND WAS SUCCESSFUL. PRESS THE
RESET KEY AND THEN REMOVE THE USB DISK DEVICE.
3. When the second message appears, press RESET to return to the Diagnostics Menu.
4. Power down your SmartPAC 2, and remove the USB disk.
UPDATE FIRMWARE
(INITIALIZATION – DIAGNOSTICS – UPDATE FIRMWARE)
To update the firmware in your SmartPAC 2, refer to Appendix B.
Using SmartPAC 2 with a Link-motion Press
(INITIALIZATION – POSITION SENSOR – RESOLVER MOTION MODE)
If your SmartPAC 2 is installed on a link-motion press, you need to determine whether to use
NORMAL MOTION or LINK MOTION for your RESOLVER MOTION MODE setting (see
page 4-4) and, if you are using a servofeed with a Wintriss ServoFeed Interface (SFI), how
you will compensate for the different upstroke and downstroke speeds on your link-motion
press.
To Next Page
Loading...
Need help?
General
