SmartPAC 2 User Manual 1126700
Installation 2-33
Turning on Power to SmartPAC 2
To turn on power to SmartPAC 2, do the following:
1. Make sure there is no die in the press.
2. Turn the Program/Run key to PROG.
3. Power up the SmartPAC 2.
The green Power light on the SmartPAC 2 front panel illuminates, a red SmartPAC 2
screen appears for a few seconds, then the display goes off and the Brake Warning LED
flashes at approximately two-second intervals while SmartPAC 2 completes its startup
routine. This can take up to one minute. Eventually, the Main Program Menu appears
(see Figure 2-21, page 2-34).
Figure 2-20. SmartPAC 2 Startup Screen
For help in using the SmartPAC 2 keyboard and display, see Chapter 3.
If you turn the Program/Run key and nothing happens, press RESET repeatedly until SmartPAC 2
changes modes. Before turning the Program/Run key, make sure SmartPAC 2 is in the Main
menu for the mode it is in. If it is not, press RESET repeatedly until the Main menu appears. Then
turn the Program/Run key.
• If an error message displays when SmartPAC 2 starts up, press RESET.
• If the error message continues to appear after your press RESET, find the message in Chapter
7 and follow the instructions for correcting the problem. If you cannot find the error message or
cannot fix the problem, contact Wintriss Tech. Support.
To Next Page
Loading...
Need help?
General
