1126700 SmartPAC 2 User Manual
D-12 SmartPAC to SmartPAC 2 Upgrade
AC Wiring on SmartPAC 2
Connect the AC input wires and ground wire as shown in Figure D-2.
Make your ground connection as follows:
• For SmartPAC 2 enclosure: Connect your ground (green or green/yellow) wire to the
set screw terminal on the inside of the enclosure, as shown in Figure D-2. Strip the
ground wire about 1/4” (6.4 mm) from the end, loosen the screw on the terminal, slide
the wire in the hole, and tighten the screw to secure the wire in place.
• For SmartPAC 2 panel mount: Connect the ground wire to the ground stud located on
the face plate below the AC input terminal block.
Restoring Tools to SmartPAC 2
You can use SBR to restore backed-up tools from a SmartPAC 1 to a SmartPAC 2 via a
connected laptop, or, if the SmartPAC 2 is on a network, you can restore tool settings from a
network server. However, you cannot restore SmartPAC 1 Initialization settings to
SmartPAC 2. To transfer this information to SmartPAC 2, you should copy Initialization
settings to a paper form before performing the back-up, then, after restoring the other setup
information, enter the Initialization settings from the form manually into SmartPAC 2 (see
System Checkout, page D-14).
Figure D-2. SmartPAC 2 AC Wiring (Inside Enclosure, Top Right)
LINE
NEUTRAL
L1
(High)
Terminal block
Ground
Setscrew
terminal
L2
(Neutral)
AC Input Voltage: 115/230 V
To Next Page
Loading...
Need help?
General
