1126700 SmartPAC 2 User Manual
6-14 Run Mode
A red sensor actuation block is always actuated except when there is a sensor fault since it is
normally grounded. Actuation blocks for yellow sensors are only actuated during a fault
condition.
When the press is stopped, the actuation block shows the state of the sensor at that point in the
stroke. The actuation block for an unused sensor may display if a sensor has been connected
to that input by mistake. The Sensor Status screen shows any change in the state of an input
whether the input is being used or not.
Adjusting DiProPAC 32 Sensors
You access DiProPAC 32 sensors on the SmartPAC 2 Main Run Menu via the DIPROPAC
1-16 and DIPROPAC 17-32 items, as shown in Figure 6-14.
When you select the DIPROPAC 1-16 item, the Die Protection Sensor menu for sensors 1-16
displays. On this menu, you can adjust settings for green and green special sensors as
described in Adjusting the Ready Signal for Green Sensors, page 6-10 and Adjusting the
Stroke Preset for Green Special Sensors, page 6-12.
When you select DIPROPAC 17-32, the Die Protection Sensor menu for sensors 17-32
displays (see Figure 6-15, page 6-15, which shows the sensors that are used as examples in
Chapter 5).
When programmed as green sensors, sensors 17-32 cannot be adjusted in Run mode since
they share their Ready signals or stroke counts with one of the first sixteen sensors. You can,
however, adjust the Ready signal or stroke count for the sensor on which settings are based.
Adjustments are automatically duplicated in all linked sensors 17-32.
Figure 6-14. Main Run Menu with DIPROPAC 1-16 and DIPROPAC 17-32 Items Shown
To Next Page
Loading...
Need help?
General
