SmartPAC 2 User Manual 1126700
Reporting Downtime and Scrap to SFC F-25
3. Repeat step 2 for the remaining scrap entries associated with the current job until the job is
completed.
Adjusting the Good Parts Counter
The Run mode Counters screen enables you to increase the Good Parts count to adjust for
count inaccuracies, such as when good parts may be produced but not counted in Setup mode
or during Fault conditions. The count can be increased by up to 1,000 parts at a time.
The Counters screen in Program mode allows you to increase Good Parts by larger amounts
(see Adjusting the Good Parts Counter in Program Mode, next page). This capability is
useful if new firmware is installed in the middle of a job, causing the Good Parts counter to
reset to zero.
Adjusting the Good Parts Counter in Run Mode
To increase the Good Parts count in Run mode, do the following:
1. Select the GOOD PARTS COUNT field on the Counters screen.
Figure F-18. Counters Screen with Scrap Value Updated to 40 Items
You can only increase the value maintained by the Good Parts counter. You cannot decrease the
Good Parts counter except by entering scrap values.
You cannot adjust the Good Parts counter if the CHG GOOD PRTS CNT item on the Security
Access Menu has been set to “NO CHANGES ALLOWED.”
To Next Page
Loading...
Need help?
General
