1126700 SmartPAC 2 User Manual
4-34 Initialization Mode
SETUP NETWORK
(INITIALIZATION – SETUP NETWORK)
The SETUP NETWORK item on the Main Initialization Menu allows you to set up
SmartPAC 2’s E-mail and SmartView functions and to make other settings necessary to
configure a SmartPAC 2 network. You make these settings on the Network Setup Utility
screen, which is shown in Figure 4-26.
E-MAIL FUNCTION
(INITIALIZATION – SETUP NETWORK – E-MAIL FUNCTION)
SmartPAC 2’s E-mail function allows you to send e-mails to individuals in your SmartPAC 2
network and to other recipients, such as Wintriss Tech. Support, via the Internet. If you plan
to use E-mail, do the following to enable this function:
• Your network administrator must connect SmartPAC 2 to your computer network before you can
use e-mail messaging or SmartView remote viewing utility. For e-mail, your network must have
a valid SMTP mail server.
• If your network requires static IP addresses, your network administrator should call Wintriss
Tech. Support. See CHANGE NETWORK SETTINGS, page 4-37.
Figure 4-26. Network Setup Utility Screen
• Consult with your network administrator when setting up e-mail.
• Use the SmartView remote viewing utility (see next item) to set up e-mail messages and
recipients.
To Next Page
Loading...
Need help?
General
