Tools
Xerox
®
DocuCentre
®
SC2020
User Guide
168
Incoming Defaults
Purpose: To configure settings for incoming fax.
Receive Mode
Purpose: To select the default fax receiving mode.
Values:
Ring Tone Volume
Purpose: To set the volume of the ring tone, which indicates that an incoming call is a telephone call
through the internal speaker when [Receive Mode] is set to [TEL/FAX Mode].
Values:
Auto Answer Setup
TEL Mode Automatic fax reception is turned off. You can receive a fax by picking up
the handset of the external phone and then pressing the remote receive
code, or by selecting [Manual Receive] in [OnHook] to [On] (you can hear
voice or fax tones from the remote device) and then pressing the <Start>
button. For more information on [Manual Receive], refer to
Receiving a
Fax Manually in the TEL Mode
on page 114.
Fax Mode Automatically receives faxes.
TEL/FAX Mode When the device receives an incoming fax, the external telephone rings
for the time specified in [Auto Answer TEL/FAX], and then the device
automatically receives a fax. If an incoming call is not a fax, the device
beeps from the internal speaker indicating that the call is a telephone
call.
Ans/FAX Mode This mode is used when this device shares a telephone line with an
answering device for example. This device monitors fax signals and
receives faxes, if a fax reception sound is detected. If the phone
communication in your region is serial, this mode is not supported.
DRPD Mode Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a
separate number for faxing with a distinctive ring pattern, configure the
fax setup to monitor for that specific ring pattern.
Off Turns off the volume of the ring tone.
Min Sets the volume of the ring tone to minimum.
Middle Sets the volume of the ring tone to middle.
Max Sets the volume of the ring tone to maximum.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
