Phaser 6121MFP Service Manual 3-27
Error Messages and Codes
008D Receiver’s protocol of DIS is received, but remote side can not receive
documents temporarily. This can be caused by out of paper condition
or other reason.
008E Remote side CSI number not defined in machine one touch or speed
dial directory.
008F Modem not ready to receive V.34 data within 6 seconds after received
CFR signal.
0090 Called side document not ready for polling.
0091 Sending DCS+TCF signal 3 times consecutively but no signal in
response from receiver.
0092 Remote side disconnected within transmitting phase.
0093 Received DCN signal after sending out DCS signal for V.34.
0094 Time out during transmit ECM frame or RCP command.
0095 Wrong ID number when Polling RX.
0099 Remote side disconnect after primary channel.
009A Cannot detect any signal after sending CI signal.
009C Received DCN after sending DTC in V.34 polling RX.
009D Remote side hang up before V.34 modem enter phase 2 state in V.34
polling RX.
009F No response received from other side after sending PPS_EOM signal.
00A0 User stopped or canceled transmission job.
00A1 Document jam within transmission.
00AE Cannot finish V.8 procedure or detect V.21 signal within 30 seconds
after CM signal.
OOAF Modem can not enter into control channel after TX side sending RCP
signal for V.34.
00B0 No command received after resending DCS signal in V.34 TX.
00B1 Cannot finish V.8 procedure or detect V.21 signal within 35 seconds
after ANSam signal.
00B2 Cannot detect phase 2 signal within 30 seconds after sending CJ
signal.
00B3 Cannot detect correct V.21 or JM signal after sending CM signal.
00B4 Cannot detect correct phase 2 signal within 25 seconds after CM/JM
signal exchange.
00B5 Cannot detect phase 3 signal within 25 seconds after phase 2.
00B6 Cannot detect phase 4 signal within 25 seconds after CM/JM
exchange.
00B7 Cannot detect phase 5 signal within 30 seconds after phase 4.
00B8 Remote side disconnect after sending DCS signal in V.34.
00B9 Receive T.30 signal other than DIS, DCS, CFR after sending DCS signal
in V.34.
Code Possible Causes of Error
To Next Page
Loading...
