3-28 Phaser 6121MFP Service Manual
Error Messages and Codes
00BA Did not receive correct signal after sending DTC signal in V.34.
00BB DIS signal received after sending DTC in V.34.
00BC Modem is not ready within 10 seconds after entering primary channel
in V.34.
00BD Cannot detect correct V.21 or JM signal after detected FSK frequency.
00BE Remote side has no document to be polled after V8 handshaking.
00BF Capability mismatch.
00C0 Remote side disconnect before entering primary channel in V.34.
00C1 At phase D, transmitting units out EOP 3 times consecutively, but
receive no answer from receiving unit.
00C2 Remote side disconnect after sending out V.8 CM signal.
00C4 After sending MPS signal, the received signal is not one of MCF, RTN,
PIP, PIN, RTP, or DCN.
00C5 Received DCN signal after sending MPS signal.
00C9 At phase D, sending MPS 3 times consecutively, but no answer from
receiving unit.
00CA After sending EOP signal, the received is not one of MCF, RTN, PIP,
PIN, PRI-EOP, or DCN.
00CB After sending EOP signal, received DCN signal.
00CC After sending EOM signal, the received signal is not one of MCF, RTN,
PIP, PIN, RTP, or DCN.
00CD At phase D, transmitting EOM 3 times consecutively, but receive no
answer.
00CE At phase-D, transmitting EOM, but receive DCN.
00CF Received incorrect signal after sending DTC signal for V.34 polling.
00D0 Received ERR signal after sending EOR_NULL.
00D1 Received incorrect response after sending PPS_EOP signal in V.34.
00D2 Received DCN after sending PPS_EOP signal.
00D3 Received DCN after sending PPS_NULL signal.
00D4 Received DCN after sending PPS_EOM signal.
00D8 Cannot detect correct phase 3 signal for polling within 25 seconds.
00D9 Cannot detect correct phase 3 signal after detect silence after
phase 2.
00DA Can not detect phase 4 signal within 30 seconds or remote side hang
up over 6 seconds.
00DB Cannot detect any T.30 signal within 15 seconds during phase 4.
00DC Received T.30 signal in phase 4 other than DCS, DIS or DTC.
00DE Remote side no SUB capability in V.34.
00E0 At phase-D, transmitting PPS_NULL 3 times consecutively but receive
no answer.
Code Possible Causes of Error
To Next Page
Loading...
