Phaser 6121MFP Service Manual 3-47
Error Messages and Codes
Error code: 00F2
Definition: Received incorrect response after sending EOR_MPS.
Solution:
1. Resend the fax.
2. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 00F3
Definition: Received ERR signal after sending EOR_MPS.
Solution:
1. Change the machine setting to ECM OFF, and then resend.
2. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 00F4
Definition: No response received in RR response procedure after sending
EOR_MPS.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Change the machine setting to ECM OFF, and then resend.
3. Boost the TX Level of sender's machine.
4. Boost the machine TX Level.<*1>
5. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 00F5
Definition: At phase-D, transmitting units out EOR_EOP 3 times consecutively
but receive no answer.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Change the machine setting to ECM OFF, then resend again.
3. Boost the TX Level of sender's machine.
4. Boost the machine TX Level.<*1>
5. Print out the protocol report, and provide it to Technical Support for analysis.
To Next Page
Loading...
