A-14 Phaser 6121MFP Service Manual
Reference
Receive Print ■ Memory Receive (default) – The fax prints after
the entire transmission has been received. Note
that this setting is separate from the Memory
Receive menu item at the beginning of the Receive
Options Setup Menu.
■ Print Receive – The fax begins printing as soon as
the first page has been received
Receive Mode
■ Auto RX (auto receive) – The printer always
answers an incoming call as a fax.
■ Manual Receive – The line continues to ring until
you start the receive fax function manually.
■ DRPD (Distinctive Ring Pattern1, Pattern2,
Pattern3, Pattern4) – The printer determines from
the ring pattern if the call is a voice phone call or a
fax.
Forward Specifies whether the printer should forward
incoming faxes to a specified destination and
whether to print before forwarding.
■ On – Faxes received are forwarded to the specified
fax number or email address.
■ On (Print) – Faxes received print out and are then
forwarded.
■ Off – Faxes received are not forwarded.
Footer
■ On – Fax reception information is printed in the
bottom of the printable area (footer) of the fax.
■ Off – Fax reception information is not printed in
the footer.
Select Tray Specifies which paper tray the printer uses for
printing faxes. (Selection is not possible if there is
only one tray.)
■ Tray 1
■ Tray 2 (available as an option for
Phaser 6121MFP/N or /D printer configurations
only)
Reset to Default? When selected, resets the Receive options back to
their original factory defaults.
Menu Item Description
To Next Page
Loading...
