Xerox Phaser 7760 - Page 413

January 2010
2-377
Phaser 7760 Color Laser Printer
024-984
Status Indicator RAP’s
Revised
024-984 Booklet Low Staple F
Booklet Stapler Low Staple Front signal was detected just before Stapling operation.
Booklet Stapler Low Staple Front signal was detected at power On, at initialization, or when the
Interlock was closed.
Procedure
Supply the staples. The problem is resolved.
YN
Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools >
Printer Status Page > hold the Up and Down buttons simultaneously > Run Service
Diagnostics > OK. Actuate the Booklet Stapler Low Staple Front. ‘LOW’ (staples avail-
able) is displayed.
YN
Check continuity between the Staple and Booklet PWB, and between the Booklet
PWB and Finisher PWB (Figure 1). The continuity check is OK.
YN
Repair the open circuit or short circuit.
Replace the Booklet Stapler Low Staple Front (PL 21.16). If the problem continues,
replace the Finisher PWB (PL 21.12).
Replace the Finisher PWB (PL 21.12). If the problem continues, replace the Booklet PWB
(PL 21.12).
If the problem continues, replace the Finisher PWB (PL 21.12). If the problem continues,
replace the Booklet PWB (PL 21.12).
Figure 1 024-984 Stapler Front Assembly
A
A