Xerox Versant 80 Press - Page 183

Recommended SolutionPossible CauseFault CodeFault Area
Perform the following in this order:
1. Remove or clear any
jammed paper.
2. Replace and fan the paper
in tray.
3. Power Off / On the press.
4. If problem still persists,
contact the Customer Sup-
port Center.
Pre-registration sensor jam
during paper transporta-
tion from Bypass Tray
078-110Bypass Tray
Regi sensor not turned on
fault during paper trans-
portation from Bypass
Tray
078-111Bypass Tray
Perform the following in this order:
1. Remove or clear any
jammed paper.
2. Replace and fan the paper
in tray.
3. Replace the OHCF Feed
Rolls; refer to Replacing the
OHCF Feed Rolls (Trays 6
and 7).
Pre-registration sensor
jam; during paper trans-
portation, feed sensor is
not turned on within peri-
od of time paper is trans-
porting from tray
078-100,
078-101,
078-102,
078-103
Tray 6
Perform the following in this order:
1. Remove or clear any
jammed paper.
2. Replace and fan the paper
in tray.
3. Replace the OHCF Feed
Rolls; refer to Replacing the
OHCF Feed Rolls (Trays 6
and 7).
Pre-registration or feed
sensor jam during paper
transportation from Tray
7
078-150,
078-151
Tray 7
14-21Xerox
®
Versant
®
80 Press
User Guide
Press Problem Solving