3. Locate the Staple Waste Container (R5) in the finisher, and move the lock lever to
the unlock position.
4. Hold R5 as shown in the figure and remove the staple waste container from the press.
5. Place the used staple waste container into a supplied plastic bag.
Note
Do not return a disassembled (used) container to the Customer Support Center.
6. Hold the new staple waste container by the R5 handle area and push it into the press.
Note
To prevent injury, do not put your fingers on top of the container.
7. Push R5 until the lock lever moves to the locked position.
8. Close the right cover on the finisher.
Note
A message will display and the machine will not operate if the right cover is open
even slightly.
24-9Xerox
®
Versant
®
80 Press
User Guide
Standard Finisher / Booklet Maker Finisher
To Next Page
Loading...
