Xerox Versant 80 Press - Page 361

Recommended solutionPossible causeFault code
• If a jam, open the Top Left and Right
Covers of the Finisher Module.
• Carefully remove all sheets and paper
scraps from jam clearance areas.
• Make sure the Top Left and Right Covers
are fully closed.
• Check the Trimmer Waste Container. If
full, empty it and reinsert into the mod-
ule. Make sure it is pushed in completely.
• Follow any instructions on the touch
screen.
• If fault persists, power off/on the press.
• If fault persists, call for service.
Open interlocks. A top cover
or door is open. A jam or
fault occurred with the
Module
013-303, 013-304,
013-308
• Open the Top Left and Right Covers of
the Finisher Module.
• Carefully remove all sheets and paper
scraps from jam clearance areas.
• Make sure the Top Left and Right Covers
are fully closed.
• Check the Trimmer Waste Container. If
full, empty it and reinsert into the mod-
ule. Make sure it is pushed in completely.
• Follow any instructions on the touch
screen.
• If fault persists, call for service.
Static jams013-900, 013-901,
013-905 to 013-911,
013-915 to 013-919
• Pull open the container and empty any
trimmer scraps from it.
• Reinsert the container into the module.
• Make sure the container is pushed in
completely.
• If fault persists, power off/on the press.
• If fault persists, call for service.
The Trimmer Waste Contain-
er is full or has a fault
013-940
25-11Xerox
®
Versant
®
80 Press
User Guide
SquareFold Trimmer Module