General Care
Xerox WorkCentre 3550
User Guide
159
Document Glass and Constant Velocity Transport (CVT) Glass
To ensure optimum print quality at all times, regularly clean the glass areas of your machine. This helps
avoid output with lines, streaks, smears, spots and other marks that may appear on the output when
scanning documents.
When you use the document feeder, your documents will pass over the stationary scanner using the
Constant Velocity Transport (CVT) glass. Any dirt or marks on this piece of glass will cause lines or
streaks on your copies, faxes or scanned images. Also, any marks or dirt on the Constant Velocity
Transport (CVT) glass cover may show through the document and appear on your scanned images.
1. Use a lint-free cloth, lightly dampened with Xerox Anti-Static
or general cleaning fluid or another suitable non-abrasive
glass cleaner to clean the document glass
and the
Constant Velocity Transport glass .
2. Wipe away any residue with a clean cloth or paper towel.
3. Use a lint-free cloth, lightly dampened with water, Xerox
cleaning fluid or Xerox film remove to clean the under side of
the document feeder
and the Constant Velocity Transport
glass cover .
Control Panel, Document Feeder and Output Tray
Regular cleaning keeps the display, control panel and other machine areas free from dust and dirt.
1. Use a soft, lint-free cloth, lightly dampened with water.
2. Wipe clean the entire area of the control panel, including the display.
3. Wipe clean the document feeder, output tray, paper trays and other outside areas of your
machine.
4. Remove any residue with a clean cloth or paper towel.
Internal Areas
During the printing process, paper, toner, and dust particles can accumulate inside the machine. This
can cause print quality problems, such as toner specks or smearing. Cleaning the inside the machine
clears and reduces these problems.
1. Turn the machine off and unplug the power cord. Wait for the
machine to cool down.
2. Release both latches on the side of the front door and open
the door.
3. Pull the print cartridge out and place it on a clean flat
surface.
CAUTIONS:
• To prevent damage to the print cartridge, do not expose
it to light for more than a few minutes. Cover it with a piece of paper, if necessary.
• Do not touch the green surface underside of the print cartridge. Use the handle on the
cartridge to avoid touching this area.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
