Copy Procedure
Xerox WorkCentre 3550
User Guide
26
Copy Procedure
This section describes the basic procedure for making copies. Follow the steps below.
• Load the Documents on page 26
• Select the Features on page 27
• Enter the Quantity on page 28
• Start the Job on page 28
• Check the Job Status on page 28
• Stop the Job on page 28
If an authentication feature is enabled, you may need an account before using the machine. To get an
account, or for more information, contact the System Administrator.
Load the Documents
You can load the documents to be copied either on the document glass or through the document
feeder.
Document Feeder
The following steps explain how to load documents using the document feeder:
1. Before loading the documents into the document feeder, ensure they are in good condition and
remove all staples and paper clips.
2. Insert the documents neatly into the document feeder, face
up. The first page should be on top with the headings
towards the left of the machine.
Note: Up to 60 sheets of 20 lb (75 g/m²) bond paper can be
loaded. Weight ranges from 12.5 lb to 28 lb (50 - 120 g/m²) -
refer to Specifications on page 191 for further information.
3. Place the documents in between the guides placing the left
edge in the document feeder, and position the guides to just
touch the edge of the documents.
To Next Page
Loading...
