System Setup
Xerox WorkCentre 3550
User Guide
152
7. Continue customizing the Sound Settings as required, then press Stop to return to ready mode.
Maintenance
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight System Setup and press OK.
3. Enter the Administrator’s Password using the keypad. Refer to Accessing the Setup Options on
page 128 for instructions.
4. Press the up/down arrows to highlight Maintenance and press OK.
The following Maintenance options and settings are available:
Note: * indicates the factory default setting.
5. Press the up/down arrows to highlight the option required and press OK.
6. Press the up/down arrows to highlight the setting required and press OK to save the selection.
7. Continue customizing the Maintenance options as required, then press Stop to return to ready
mode.
Clear Settings
You can selectively clear information stored in your machine’s memory.
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight System Setup and press OK.
3. Enter the Administrator’s Password using the keypad. Refer to Accessing the Setup Options on
page 128 for instructions.
4. Press the up/down arrows to highlight Clear Settings and press OK.
Option Description Settings
CLR Empty Msg Use this option to enable a user
to clear the message which
displays when the Print
Cartridge requires changing.
•Off *
•On
Supplies Life Use this option to view or print
usage information for the
supplies.
•Supplies Info •Print? Yes | No
•Total •125 Pages
•ADF Scan •125 Pages
•Platen Scan •125 Pages
Ton e r Lo w Ale r t Use this option to enable an
alert to display when the toner
is low.
•On *
•Off
To Next Page
Loading...
