Network Settings
Xerox WorkCentre 3550
User Guide
154
Network Settings
You may set up the network using the machine's display screen. Before doing that, you must have the
relevant information concerning the type of network protocols and computer system you use. If you
are not sure which setting to use, contact your System Administrator to configure this machine on the
network, or refer to the System Administrator Guide for instructions.
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight Network Settings and press OK.
3. Enter the Administrator’s Password using the keypad. Refer to Accessing the Setup Options on
page 128 for instructions.
The following Network Settings options and settings are available:
4. Press the up/down arrows to highlight the option required and press OK.
5. Press the up/down arrows to highlight the setting required and press OK to save the selection.
6. Continue customizing the Network Setting options as required, then press Stop to return to ready
mode.
Option Description
TCP/IP v4
TCP/IPv6
Select appropriate protocol and configure
parameters to use the network environment.
Network Services Use to enable 802.1x and CentreWare Internet
Services.
Ethernet Speed Configure the network transmission speed.
Network Ping Test Ping is a computer network administration utility
used to test whether a particular host is reachable
across an Internet Protocol (IP) network and to
measure the round-trip time for packets sent from
the local host to a destination computer, including
the local host's own interfaces.
Clear Settings Reverts the network settings to the default values.
Print Network Info. This list shows information on your machine’s
network connection and configuration.
To Next Page
Loading...
