Printing using Macintosh
Xerox WorkCentre 3550
User Guide
97
Paper
Set Paper Type to correspond to the paper loaded in the tray from which you want to print. This will let
you get the best quality printout. If you load a different type of print material, select the corresponding
paper type.
Printer Features
Printer Features tab provides Reverse Duplex Printing and Fit to Page options. Select Printer
Features from the drop-down list under Orientation to access the following features.
• Reverse Duplex Printing: The document is printed 2 sided and the second side images are rotated
180 degrees.
• Fit to Page: This option allows you to scale your print job to any selected paper size regardless of
the document size. This can be useful when you want to check fine details on a small document.
Toner Save Mode
Selecting this option extends the life of your print cartridge and reduces your cost per page without a
significant reduction in print quality.
• Printer Setting: Select this option to use the settings made on the control panel of the printer.
• On: Select this option to allow the printer to use less toner on each page.
• Off: If you do not need to save toner when printing a document, select this option.
Printing Multiple Pages on one Sheet
You can print more than one page on a single sheet of paper. This feature provides a cost-effective way
to print draft pages.
1. Open an application, and select Print from the File menu.
2. Select Layout from the drop-down list under Orientation. In the Pages per Sheet drop-down list,
select the number of pages you want to print on one sheet of paper.
3. Select the other options you want to use.
4. Click Print, then the machine prints the selected number of pages you want to print on one sheet
of paper.
Two Sided Printing
You can print on both sides of the paper. Before printing in the duplex mode, decide on which edge you
will be binding your finished document. The binding options are, as follows:
• Long-Edge Binding This option is the conventional layout used in book binding.
• Short-Edge Binding This option is the type often used with calendars.
1. From your Macintosh application, select Print from the File menu.
2. Select Layout from the drop-down list under Orientation.
3. Select a binding orientation from the Two Sided Printing option.
4. Select the other options you want to use.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
