Troubleshooting
Xerox WorkCentre 3550
User Guide
166
Bypass Tray
1. If the paper is not feeding properly, pull the paper out of the
machine.
2. Release both latches on the side of the front door and open
and close the door.
3. Re-load the Bypass Tray to resume printing.
Inside the Machine
CAUTION: The fuser area is hot. Take care when removing paper from the machine.
1. Release both latches on the side of the front door and open
the door. Pull the print cartridge out, lightly pushing it down.
2. Remove the jammed paper by gently pulling it straight out.
3. Replace the print cartridge and close the front door. Printing
automatically resumes.
Output Area
1. Release both latches on the side of the front door and open and close the door. The jammed
paper is automatically ejected from the machine.
2. If you do not see the jammed paper, go to next step.
To Next Page
Loading...
