Yamaha CS50 - Installing the Autolube Oil Pump; Installing the DC-CDI Magneto

ENG
ENGINE ASSEMBLY AND ADJUSTMENT
4-25
INSTALLING THE AUTOLUBE OIL PUMP
1. Install:
• circlip 
• pin 
• pump drive gear 
• circlip 
2. Apply:
• grease with lithium soap base
(on the o-ring )
3. Install:
• autolubrication pump 
4. Apply:
• grease with lithium soap base
(on the autolubrication pump gear , )
INSTALLING THE DC-CDI MAGNETO
1. Install:
• gasket
2. Apply:
• grease with lithium soap base
(on the oil seal )
3. Pass the wheel cable through the crankca-
se orifice.
4. Install:
• stator assembly
5. Install:
• woodruff key 
• rotor 
• plain washer 
•nut 
Screw (autolubrication pump)
4 Nm (0.4 m • kg)
Lithium soap base grease
15 cc (0.92 cu • in)
Screw (stator assembly)
8.5 Nm (0.85 m • kg)