Yamaha CS50 - Installing the Starter System

ENG
ENGINE ASSEMBLY AND ADJUSTMENT
4-30
INSTALLING THE STARTER SYSTEM
1. Install:
• bushing 
• bearing 
• starter wheel gear 
• starter clutch 
NOTE:
• Apply grease with a lithium soap base on
the bearing .
• Apply molybdenum disulphide oil on the pin
(starter clutch) .
2. Install:
• flat washer 
• idle gear 
• flat washer 
• plate  (intermediate gear)
NOTE:
Apply engine oil on the intermediate gear .
3. Install:
• starter motor 
NOTE:
Apply grease with a lithium soap base on the
o-ring of the starter motor.
Screw (intermediate gear plate)
8 Nm (0.8 m • kg)
Screw (starter motor)
13 Nm (1.3 m • kg)