EasyManua.ls Logo

YASKAWA MP2100 Series - Page 365

YASKAWA MP2100 Series
455 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11 SVR Virtual Motion Module
11.3.2 Motion Command Details
11-26
(5) Latch (LATCH)
The latch function cannot be used for the SVR. The LATCH command will thus perform the same operation as
the INTERPOLATE command.
(a) Operating Procedure
Note: The following position information is updated during command execution.
• Machine Coordinate Target Position (TPOS) (IL

OE)
• Target Position (CPOS) (IL

10)
• Machine Coordinate System Position (MPOS) (IL

12): MPOS is always equal to CPOS.
• Machine Coordinate Feedback Position (APOS) (IL

16): APOS is always equal to CPOS.
No. Execution Conditions Confirmation Method
1 There are no alarms. Both IL

02 and IL

04 are 0.
2 The Servo ON condition. IB

001 is ON.
3 Motion command execution has been completed. IW

08 is 0 and IB

090 is OFF.
Set the motion setting parameters.
• Target Position: OL

1C
• Acceleration/Deceleration Filter Type:
OW

03
• Speed feed forward compensation can be applied.
• Generate the target position data each high-speed scan from the
ladder logic program.
• The travel speed is calculated automatically.
• The Command Pause (OB

090) cannot be used.
• The Command Abort (OB

091) cannot be used.
• Change the motion command to stop interpolation execution.
Execute the LATCH motion command.
• Set OW

08 to 6.
Positioning starts.
• IW

08 will be 6 during execution.
Change the Target Position (OL

1C)
every high-speed scan.
Positioning completed.
• IB

0C1 will turn ON.
Execute NOP motion command.
• Set OW

8 to 0.
Position
0
Speed (%)
Time (t)
OW08 = 5
(EX_INTERPOLATE)
IW08 = 5
(EX_INTERPOLATE)
IB090 (BUSY)
IB098 (COMPLETE)
IB0C0 (DEN)
IB0C1 (POSCOMP)
IB0C3 (NEAR)

Table of Contents

Related product manuals