YASKAWA P1000

No.
(Addr.
Hex)
Name Description Values Page
F7-72
(078C)
<1>
PZD3 Read
Sets MEMOBUS/Modbus address for PZD3 Read (PPO Read).
Values 0 to 2 disable the PZD3 Read.
Default: 0
Min.: 0
Max.: FFFF
–
F7-73
(078D)
<1>
PZD4 Read
Sets MEMOBUS/Modbus address for PZD4 Read (PPO Read).
Values 0 to 2 disable the PZD4 Read.
Default: 0
Min.: 0
Max.: FFFF
–
F7-74
(078E)
<1>
PZD5 Read
Sets MEMOBUS/Modbus address for PZD5 Read (PPO Read).
Values 0 to 2 disable the PZD5 Read.
Default: 0
Min.: 0
Max.: FFFF
–
F7-75
(078F)
<1>
PZD6 Read
Sets MEMOBUS/Modbus address for PZD6 Read (PPO Read).
Values 0 to 2 disable the PZD6 Read.
Default: 0
Min.: 0
Max.: FFFF
–
F7-76
(0790)
<1>
PZD7 Read
Sets MEMOBUS/Modbus address for PZD7 Read (PPO Read).
Values 0 to 2 disable the PZD7 Read.
Default: 0
Min.: 0
Max.: FFFF
–
F7-77
(0791)
<1>
PZD8 Read
Sets MEMOBUS/Modbus address for PZD8 Read (PPO Read).
Values 0 to 2 disable the PZD8 Read.
Default: 0
Min.: 0
Max.: FFFF
–
F7-78
(0792)
<1>
PZD9 Read
Sets MEMOBUS/Modbus address for PZD9 Read (PPO Read).
Values 0 to 2 disable the PZD9 Read.
Default: 0
Min.: 0
Max.: FFFF
–
F7-79
(0793)
<1>
PZD10 Read
Sets MEMOBUS/Modbus address for PZD10 Read (PPO Read).
Values 0 to 2 disable the PZD10 Read.
Default: 0
Min.: 0
Max.: FFFF
–
<1> Available in drive software versions PRG: 8503 and later.
<2> Parameter setting value is not reset to the default value when the drive is initialized.
<3> Available in drive software versions PRG: 8502 and later.
<4> Values shown are for the MECHATROLINK-II option (SI-T3). Values for MECHATROLINK-III option (SI-ET3) are: Min: 03, Max.: EF
<5> Cycle power for setting changes to take effect.
<6> If F7-13 is set to 0, all IP addresses (F7-01 to F7-04) must be unique.
B.7 F: Communication Options
YASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual
453
B
Parameter List