CHAPTER 3MANUAL DEFIBRILLATION
3–8 www.zoll.com 9650-0912-01 Rev. N
1 Select DEFIB
Turn the Mode Selector to DEFIB. The unit automatically defaults to 120 joules or the
preconfigured first shock energy selection.
PADS are selected as the ECG source when the instrument is turned to MONITOR or DEFIB
and paddles are not connected to the OneStep cable. You may select any of the other ECG leads
by pressing the front panel LEAD button.
Energy Select
Look at the display, and verify the selected energy is appropriate. The default energy selections
for adult patients are:
• Shock 1 - 120 joules
• Shock 2 - 150 joules
• Shock 3 - 200 joules
When used with OneStep Pediatric electrodes, the default energy selections are:
• Shock 1 - 50 joules
• Shock 2 - 70 joules
• Shock 3 - 85 joules
WARNING! When used with other pediatric defibrillation electrodes, defibrillator energies must be
set manually based on site-specific institutional protocols for pediatric defibrillation.
After the third shock, all subsequent shocks are delivered at the same energy as the third shock
in both Adult and Pediatric modes.
If medical protocol allows, you may select a different energy level using the ENERGY
SELECT buttons on the front panel.
1
RECORDER
DEFIB
OFF
MONITOR
PACER
3
SHOCKSHOCK
ENERGY
SELECT
ENERGY
SELECT
ANALYZEANALYZE
CHARGECHARGE
2
1
To Next Page
Loading...
Need help?
General
