Name: ZOLL R Series
Brand: ZOLL
Rating: 4 (1 reviews)

To Next Page

To Previous Page

CHAPTER 12 MAINTENANCE

12–10 www.zoll.com 9650-0912-01 Rev. N

Figure 12-6. Inserting the Paper and Closing Printer Door

After the paper is loaded, press the RECORDER button to resume printing.

Note: To ensure you have loaded the paper properly, check to make sure the arrows printed

on the red, grid side of the paper point upward.

Cleaning the Print Head

To clean the recorder print head, perform the following steps:

1. Press the release button, and allow the printer door to open (see Figure 12-5); then remove

any paper.

2. Locate the printhead along the front floor of the printer compartment, just below the release

button.

3. Gently wipe the printhead with a cotton swab moistened with isopropyl alcohol, and dry any

residual alcohol with another dry cotton swab.

Figure 12-7. Cleaning the Print Head

4. Place the paper back into the unit and close the cover (see Figure 12-6).

3P/3P/

Other manuals for ZOLL R Series

Questions and Answers:

Need help?

Do you have a question about the ZOLL R Series and is the answer not in the manual?

General