ZOLL R Series Service Manual

R Series Service Manual
9650-0903-01 Rev. L 3-1
Chapter 3
Disassembly Procedures
This chapter provides instructions on how to disassemble and reassemble the R Series unit, and includes the following sections:
“Removing the Cable Caddy” on page 3-3
“Removing the Handle” on page 3-6
“Removing the Recorder, AC Charger and Battery Well” on page 3-7
“Removing the Front Panel Assembly” on page 3-12
“Removing the Side Panels” on page 3-16
“Removing the Connector Panel and Bezel” on page 3-18
“Removing the ECG Input Connector” on page 3-20
“Removing the NIBP Assembly” on page 3-21
“Removing the System Brick Assembly” on page 3-23
“Disassembling the System Brick Assembly” on page 3-28
“Discharging Capacitor” on page 3-34
“Removing the Communication Module” on page 3-35
Required Equipment
• #1 Philips head screwdriver
• #2 Philips head screwdriver
• Hex head screwdriver

ZOLL R Series Specifications

General

Defibrillator Type	Manual and AED
Pacing	Yes
ECG Monitoring	Yes
SpO2 Monitoring	Yes
FAST-SpO2	Yes
IP Rating	IP55
Defibrillator Waveform	Biphasic
Energy Levels	1-360 Joules
Display	LCD
Pacer Type	Demand
Pacer Rate	30-180 ppm
Pacer Output	0 – 140 mA
EtCO2 Monitoring	Optional
NIBP Monitoring	Optional
Temperature Monitoring	Optional
Printer	Integrated
Battery Type	Lithium-ion
CPR Feedback	Yes
Data Storage	Internal memory
Connectivity	USB