EasyManua.ls Logo

Zte ZXR10 2928 - Configuring Extended ACL

Zte ZXR10 2928
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 7 Service Configuration
Confidential and Proprietary Information of ZTE CORPORATION 113
3. To clear the STP trunkcost, use command clear stp
instance <0-15>trunk <trunkid>cost in global configuration
mode. This is shown in
Table 151.
TABLE 149 SET STP COMMAND
Format Mode Function
clear stp instance <0-
15>trunk<trunkid>cost
Global config This clear the
STP instance
trunkcost
Result: This clears the STP instance trunkcost.
4. To clear the STP name, use command clear stp
name<0-15>trunk <trunkid>cost in global configuration
mode. This is shown in
Table 151.
TABLE 150 SET STP COMMAND
Format Mode Function
clear stp name
<0-15>
Global config This clear the STP
name
Result: This clears the STP name.
5. To Enable/Disable the STP, use command set stp
{enable|disable} in global configuration mode. This is
shown in
Table 151.
TABLE 151 SET STP COMMAND
Format Mode Function
set stp
{enable|disable}
Global config This enable/disable
the STP
Result: This is used to enable/disable the STP.
6. To set the STP aging time, use command set stp agemax
<6-40> in global configuration mode. This is shown in
Table
152.
TABLE 152 SET STP AGEMAX COMMAND
Format Mode Function
set stp agemax <6-
40>
Global
config
This sets the STP aging
time
Result: This sets the STP aging time.
7. To set edge port, use command set stp edge-port
{add|delete} port <portlist> in global configuration mode.
This is shown in
Table 153.

Table of Contents

Related product manuals