ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual (Volume I)
252 Confidential and Proprietary Information of ZTE CORPORATION
Format Mode Function
<name> name
Result: This sets cluster name.
2. To set a time interval for handshake between command
switch and member switch, use command set group
handtime <1-300> in group config mode. This is shown
in
Table 415.
TABLE 415 SET GROUP HANDTIME COMMAND
Format Mode Function
set group
handtime <1-
300>
group config This sets a time
interval for
handshake between
command switch
and member switch
Result: This sets a time interval for handshake between
command switch and member switch.
3. To set effective holding time of information about
switches in cluster, use command set group holdtime <1-
300> in group config mode. This is shown in
Table 416.
TABLE 416 SET GROUP HOLDTIME COMMAND
Format Mode Function
set group
holdtime <1-300>
group config This sets effective
holding time of
information about
switches in cluster
Result: This sets effective holding time of information about
switches in cluster.
4. To set IP address of internal public SYSLOG Server of
cluster, use command set group syslogsvr < A. B. C.
D > in group config mode. This is shown in
Table 417.
TABLE 417 SET GROUP SYSLOGSVR COMMAND
Format Mode Function
set group
syslogsvr < A. B.
C. D >
group config This sets IP address
of internal public
SYSLOG Server of
cluster
Result: This sets IP address of internal public SYSLOG
Server of cluster.
5. To set IP address of internal public TFTP Server of cluster,
use command set group tftpsvr < A. B. C. D > in
group config mode. This is shown in
Table 418.