Chapter 7 Service Configuration
Confidential and Proprietary Information of ZTE CORPORATION 139
TABLE 216 SET QOS POLICER PARAMETERS COMMAND
Format Mode Function
set bandwidth
geport <portlist>
packet-type
{ unicast |
nounicast |
multicast |
broadcast }
{enable |
disable }
global config
This configures the
packet-type of
geport ingress
session
Result: This configures the packet-type of geport ingress
session of flux monitor.
17. Remarking the VLAN is to remark the VLAN attribution of
the designated flow. To remark the VLAN, use command
set policy vlan-remark in acl <1-349> rule <1-500> <1-
4094> {untagged|tagged|all} {nested|replaced} in
global configuration mode. This is shown in
Table 217.
TABLE 217 SET POLICY VLAN REMARK COMMAND
Format Mode Function
set policy vlan-remark
in acl <1-349> rule
<1-500> <1-4094>
{untagged|tagged|all}
{nested|replaced}
global config This remarks the
VLAN
Result: This remarks the VLAN.
18. To bind the rule of flux monitor, use command set
policy policing in acl <1-350> rule <1-500> policer <0-
255> in global configuration mode. This is shown in
TABLE 218 SET POLICY POLICING IN ACL COMMAND
Format Mode Function
set policy policing
in acl <1-350>
rule <1-500>
policer <0-255>
global config This binds the rule
of flux monitor
Result: This binds the rule of flux monitor.
19. Flow mirror is to copy the designated data flow to the
monitor port, use it to monitor the network and eliminate
trouble. To configure the mirror for the traffic, use
command set policy mirror in acl <1-350> rule <1-500>
{cpu|analyze-port} in global configuration mode. This is
shown in
Table 219.