EasyManua.ls Logo

Zte ZXR10 2928 - Table 399 Set Ztp Command; Table 400 Set Ztp Port Command; Table 401 Set Ztp Trunk Command

Zte ZXR10 2928
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual Volume I
246 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 399 SET ZTP COMMAND
Format Mode Function
set ztp
{enable|disable}
group config This enable/disable
the system ZTP
function
Result: This enable/disable the system ZTP function.
Note: By default, system ZTP function is enabled. When
system ZTP function is disabled, contents of switch topology
information table are cleared, and ZTP packets processing is
suspended.
2. To enable/disable port ZTP function, use command set
ztp port <portlist> {enable|disable} in group config mode.
This is shown in
Table 400.
TABLE 400 SET ZTP PORT COMMAND
Format Mode Function
set ztp port
<portlist>
{enable|disable}
group config This enable/disable
port ZTP function
Result: This enable/disable port ZTP function.
3. To enable/disable trunk ZTP function, use command set
ztp trunk <trunklist> {enable|disable} in group config
mode. This is shown in
Table 401.
TABLE 401 SET ZTP TRUNK COMMAND
Format Mode Function
set ztp trunk
<trunklist>
{enable|disable}
group config This enable/disable
trunk ZTP function
Result: This enable/disable trunk ZTP function.
Important! By default, ZTP function of all ports/trunks is
enabled. If ZTP function of a port/trunk is disabled, ZTP
packets processing of port/trunk is suspended.
Note: A port/trunk can collect and send ZTP information
normally only when both ZTP function of the port/trunk and
system ZTP function are enabled.
4. To configure ZTP parameters use the following commands
in group config mode as shown in
Table 402.

Table of Contents

Related product manuals