global config This enable/disable
module of syslog
Result: This enable/disable module of syslog.
5. To display configuration of syslog, use command show
syslog status in global configuration mode. This is shown
in
Table 310.
TABLE 310 SHOW SYSLOG STATUS COMMAND
Format Mode Function
show syslog
status
global config This displays
configuration of
syslog
Result: This displays configuration of syslog.
E
ND OF STEPS
Syslog has been configured on ZXR10 2920/2928/2952.
In this example, syslog in switch is enabled, level of
information is informational and all functional modules are
enabled. IP address of server is 192. 168. 1. 1 and name
of server is Srv1.
Configuration
zte(cfg)#set syslog level informational
zte(cfg)#set syslog add server 1 ipaddress 192. 168
1. 1 name Srv1
zte(cfg)#set syslog module all enable
zte(cfg)#set syslog enable
zte(cfg)#show syslog status
Syslog status: enable
Syslog alarm level: informational
Syslog enabled modules:
alarm cmdlog
Syslog server IP Name
1 192. 168. 1. 1 Srv1
zte(cfg)#
Configuring NTP
NTP (Network Time Protocol) is used by Ethernet switches to
synchronize time with other network devices. ZXR10
2920/2928/2952 provides function of NTP client and
synchronizes time with the NTP servers in network.
Result
Example
Network Time
Protocol